Skip to content

Article image
Aseptic Technique for Cell and Microbiology Work

November 21, 2026

Overview

Aseptic technique is a set of work practices that prevents the introduction of unwanted microorganisms into cell cultures, media and microbiological preparations. It combines sterile materials, a defined work zone and barriers that keep non-sterile surfaces away from sterile ones. The approach is used in cell culture, microbiology and any procedure that requires a pure culture or a sterile preparation.

Principles

Contamination reaches a culture through direct contact, droplets or settled particles. Sterile tools and vessels limit direct transfer; filtered airflow in a certified cabinet reduces particle deposition; disinfectant on gloved hands and work surfaces lowers the number of organisms at each contact. The central rule is that a sterile surface never touches a non-sterile surface. If contact occurs, the surface is treated as contaminated and is replaced or disinfected before returning to the sterile field.

Sterile materials remain sterile only while packaging is intact. After opening, the exposure time outside a controlled environment is defined by the procedure and by the risk assessment for the organism and the matrix.

Choosing the work zone

Work zone Protects Suitable for Limitation
Certified Class II biosafety cabinet Sample, operator, environment Cell culture and work with biological hazards Requires current field certification
Laminar-flow clean bench Sample only Preparation of non-hazardous media Not suitable for hazardous or pathogenic material
Disinfected bench top with local tools Sample to a limited extent Non-critical transfers of non-hazardous strains No operator or environmental protection

Procedure

  1. Plan the sequence and place vessels, media and tools inside the work zone before starting, leaving airflow paths unobstructed.
  2. Disinfect gloves and the work surface with the agent specified in the laboratory procedure and allow the stated contact time to elapse.
  3. Confirm that the airflow indicator is within the certified range and that a current certification record is available.
  4. Open packages so that sterile contents do not touch the outer surface; keep caps and lids directed downward or in a sterile holder.
  5. Handle one open vessel at a time, avoid passing tools over open vessels and change tips or tools between cultures.
  6. Close and label vessels as soon as the transfer ends, remove them from the work zone and disinfect the surface at the end of the session.
  7. Record any deviation from the written procedure together with the corrective action taken.

Quality control and troubleshooting

Symptom Likely cause Check Corrective action
Repeated contamination of controls Breach of a sterile barrier or inadequate disinfection Review work sequence and disinfectant contact time Repeat with new materials after correcting the practice
Colonies only on plates opened near the edge Turbulent airflow or blocked grilles Inspect cabinet layout and certification status Rearrange the work zone and repeat certification if needed
Different isolates from nominally identical cultures Tool or tip carry-over between samples Review tool changes between vessels Use separate tools and change tips for each transfer

Safety, ethics and limitations

Aseptic technique does not replace containment. Work with hazardous organisms, human-derived material or toxic reagents requires the containment level defined in the risk assessment and a certified cabinet. Open flames disturb cabinet airflow and are omitted unless the written procedure and the equipment manufacturer permit them. A contaminated culture is not recovered by repeating the technique; the material is discarded under the laboratory biohazard procedure and the event is documented.

Key takeaways

  • Sterile and non-sterile surfaces remain separate throughout each step.
  • The work zone is chosen for the hazard rather than for convenience.
  • Certification, contact time and tool changes are recorded controls.
  • Contamination is investigated and documented instead of being ignored.

References

  1. World Health Organization. Laboratory Biosafety Manual, 4th edition. WHO, 2020.
  2. Centers for Disease Control and Prevention and National Institutes of Health. Biosafety in Microbiological and Biomedical Laboratories (BMBL), 6th edition, 2020.
  3. European Commission. EU Good Manufacturing Practice, Annex 1: Manufacture of Sterile Medicinal Products, 2022.